Installation Instructions for ZS-LRTX V2.1
this is the assembly guide for ZSPC LRTX v2.1 chassis.
I will walk you through the whole installation process from scattered parts to finished product step by step.
This is the most optimized installation sequence.
You can follow my instructions to complete the assembly with ease.
The standard configuration of the chassis includes all the following parts and screw accessories. The names corresponding to each serial number are listed below
1 ：Front side panel
2 ：Rear side panel
3 ：Middle beam assembly
4 ：Fan bracket
5 ：Rear panel
6 ：Front panel
7 ：Top panel
8 ：Bottom panel
9 ：Hard drive bracket
11 ：Foot pad
12 ：GPU bracket fastener
13 ：Flat silicone AC power cable
14 ：PWM fan extension cable
15 ：Rear IO shield
16 ：Dual-channel 3+4 PWM fan hub
a：M34 small countersunk hex socket screw ×3 (Rear IO)
b：M354 pan head hex socket screw ×2 (GPU fixing block)
c：6#-325/16 round head hex socket screw ×4 (Power supply fixation)
d：6#-325/32 round head hex socket screw ×9 (Middle beam & fan bracket fixation)
e：M34 round head hex socket screw ×16 (Motherboard/PCIE adapter card/Fan hub/GPU baffle)
f：M315 rivet stud ×8 (Built-in fan)
g：M315 double-ended copper standoff ×4 (2.5-inch hard drive bracket)
h：M312 double-ended copper standoff ×4 (PCIE adapter card)
i：M37 double-ended copper standoff ×2 (Fan hub)
j：M330 countersunk hex socket screw ×8 (12025 fan)
k：M36 countersunk hex socket screw ×8 (12015~12018 fan)
l：M316 small countersunk hex socket screw ×4 (Bottom foot pad)
m：M38 small countersunk hex socket screw ×4 (Top panel)
n：M35 small countersunk hex socket screw ×22 (2.5-inch hard drive/PCIE adapter card/PWM hub)
o：Motherboard buzzer
p：Fan rubber pad ×4
q：Side panel magnetic sheet ×4
r：Fan magnet ×4
s：Magnetic sheet adhesive
t：H2.0 hex screwdriver
Step 1 Install Motherboard
Note: Do not mount heatsink and memory modules on the motherboard, to avoid affecting cable routing
Step 2 Install GPU, PCIe adapter card and PWM fan hub
Step 3 Install Power Supply
Note: Arrange and tie modular cables with cable ties before installing power supply. Pass GPU power cables through reserved routing slots between middle beam and front panel. Meanwhile connect motherboard power jumpers and front USB Type-C interface.
Step 4 Install GPU & Rear Expansion I/O
Note: Bend the bottom baffle before installing GPU, pliers are required
5 Install Fan & Hard Drive Bracket
Step 6 Install Memory, Cooler and Side Panel Magnetic Sheet
Note: Install the side panel magnetic sheet according to the position of the cooler. Use the included adhesive to fix it in the designated grooves on the back of the side panel.
Step 7 Install magnets inside external fan mounting holes
